From b1ffa816b3ecb8c40ea4535a0c2d5df2b9913671 Mon Sep 17 00:00:00 2001 From: Guus Sliepen Date: Sun, 21 Nov 2010 12:46:12 +0100 Subject: [PATCH] Surround pre blocks with newlines. Perl's implementation of Markdown doesn't handle pre blocks nested in lists nicely. --- examples/ipv6-network.mdwn | 6 ++++++ 1 file changed, 6 insertions(+) diff --git a/examples/ipv6-network.mdwn b/examples/ipv6-network.mdwn index 6a33e1b..607b27b 100644 --- a/examples/ipv6-network.mdwn +++ b/examples/ipv6-network.mdwn @@ -26,10 +26,12 @@ This document is to highlight an example setup for using tinc to create an IPv6 ### Configuration Files 1. On Debian/Ubuntu systems, an entry in "/etc/network/interfaces" can be used to statically assign the ::1 address for the local LAN. Example: + iface eth1 inet6 static address 2001:db8:beef::1::1 netmask 64 mtu 1280 + On non Debian/Ubuntu systems, a line can be put in a boot script, such as "ip -6 addr add 2001:db8:beef:1::1/64 dev eth1". 2. IPv6 forwarding needs to be enabled: put "echo "1" >/proc/sys/net/ipv6/conf/all/forwarding" in a boot script, or "net.ipv6.conf.all.forwarding = 1" in "/etc/sysctl.conf". @@ -38,6 +40,7 @@ This document is to highlight an example setup for using tinc to create an IPv6 4. It is assumed that the config files go into something like "/etc/tinc/link" and "/etc/tinc/nets.boot" has an entry for "link". The following table can be used to guide configuration of routers: * "routera" configuration for tinc (the master router): + >cat tinc.conf Name = routera Mode = switch @@ -64,7 +67,9 @@ This document is to highlight an example setup for using tinc to create an IPv6 ip -6 route del 2001:db8:beef::/48 dev $INTERFACE ip -6 addr del 2001:db8:beef::1/64 dev $INTERFACE ip -6 link set $INTERFACE down + * "routerb" configuration for tinc (the other non-master routers will be like this one): + >cat tinc.conf Name=routerb Mode = switch @@ -84,6 +89,7 @@ This document is to highlight an example setup for using tinc to create an IPv6 ip -6 link set $INTERFACE down 5. You can use [radvd](http://www.litech.org/radvd/) or [Quagga](http://www.quagga.net/) to perform [stateless address autoconfiguration](http://www.ietf.org/rfc/rfc2462.txt) on your LAN. This is an example zebra.conf for LAN autoconfiguration (don't forget to enable the zebra daemon): + ipv6 forwarding ! interface eth1 -- 2.20.1